From the outside, a construction site can look like controlled chaos. Inside, every day follows a plan, and every stage has checks that decide how long the building will last. Here is what actually happens between the first soil test and the day you receive your keys.
Soil testing and design
Before any drawing is final, we test the soil to understand its bearing capacity and water table. The structural engineer uses this to design the foundation — isolated footings, raft or piles — and to size columns and beams for the loads and the seismic zone that applies to Lucknow.
Foundation and plinth
Excavation is followed by PCC, reinforcement and foundation concrete. Our engineers check bar sizes, spacing, cover blocks and shuttering before every pour, and concrete cubes are cast and tested at 7 and 28 days. Anti-termite treatment and plinth protection are done before the ground floor rises.
Structure, slab by slab
Each floor repeats the same cycle: columns, beams and slab shuttering, reinforcement, inspection, then concreting and curing. Curing is where many sites cut corners; we keep slabs wet for the full curing period because strength gained in these days cannot be added later.
Masonry, services and plaster
Brickwork or block work follows the structure, with lintels and sill bands where required. Electrical conduits and plumbing lines are laid and pressure-tested before plastering so that nothing has to be broken open later.
Finishing and snagging
Flooring, waterproofing of wet areas and terraces, doors and windows, painting and fixtures come last. Before handover we walk every room with a snag list — every tile, switch, tap and joint — and close it out item by item.
What you should receive at handover
- As-built drawings and structural details
- Warranty cards for fittings and waterproofing
- Test reports for concrete and materials
- A maintenance guide for the first year
A good site is a documented site. If you would like to see one of our ongoing projects in Lucknow, contact us to arrange a site visit.
